|
This fits directly into the slot interface in
the Coolsat FTA receiver. No electronics experience
is necessary to install. It's easy, if you can
use a screw driver and plug the pre-fitted power
end into the space inside, you are done! Tools
required - a Phillips Screw Driver
Installation is easy. Simply pop the top off
your Receiver, screw in the reader with the supplied
screws, plug in the power cord into its respective
socket on the motherboard, then punch out the
perforated plastic on the front panel where the
card goes so you can insert your card.
|
|
Contact Us Toll Free
Hottest Selling Receivers
